AEG S83600CSW1 - Handbuch (Seite 15)

Problem Possible cause Solution
The appliance has no
power. There is no volt-
age in the mains socket. Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
The lamp does not
work. The lamp is in stand-by. Close and open the door.
"dEMo" appears on
the display. The appliance is in dem-
onstration mode. Keep pressed approxi-
mately 10 sec the OK but-
ton since a long sound of
buzzer is heard and the
display shut off for a short
while: appliance start
works regularly.
In case the advice does not lead to re-
sults, call the nearest brand-mark service
7.1 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
8. TECHNICAL DATA
Dimension
Height 1850 mm
Width 595 mm
Depth 660 mm
Rising Time 20 h
Voltage 230 - 240 V
Frequency 50 Hz
The technical information are situated in
the rating plate on the internal left side
of the appliance and in the energy label.
9. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance. 9.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
ENGLISH
15