AEG S83600CSW1 - Handbuch (Seite 18)

8.
Remove the handle. Unscrew the
top handle bracket from the handle
rod (h1). Unscrew the bottom handle
bracket from the door (h2)
Unscrew the top handle bracket
from the door (h3).
9.
Install the handle in the opposite
side.
Re-screw the handle bracket on the
door (h4). Turn the handle bracket
with the handle and screw them to
the door (h5) and the fitted handle
bracket (h6).
10. Remove using a tool the cover. (c1).
11. Unscrew the upper hinge pivot (c2)
and place it on the opposite side.
h1 h2 h3
h4 h5 h6
1
2
1
2
1 2
3 4
12. Re-screw the upper hinge.
13. Fit the upper door on the upper
door pivot.
14. Re-insert the upper door on the mid-
dle hinge pivot (c3 )slightly tilting
both doors.
15. Re-screw the middle hinge. Do not
forget the plastic spacer.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cab-
inet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact
the nearest After Sales Service Force.
The After Sales Service specialist will car-
ry out the reversibility of the doors at
your cost.
18 www.aeg.com