Lenze DDS v2.1 - Handbuch (Seite 28)

Drive PLC Developer Studio
L
26 DDS DE/EN 2.1
Note
Handling and installation of the system bus module is described in the Short Operating Instructions
coming with the system bus module.
Tip!
If DDS is used for the generation and simulation of automation projects only, it is not necessary to have
a connection with the automation system.
3 Software installation
Proceed as follows to install the DDS software:
1. Start Windows.
2. Insert the Drive PLC Developer Studio CD-ROM into your CD-ROM drive.
If the auto-start function of your CD-ROM drive is activated, the installation program will be
started automatically. If so, proceed with step 5.
3. Select Run... from the start menu.
4. Enter the letter for your CD-ROM drive followed by “ :\setup.exe” in the command line
(e. g. ” e:\setup.exe“) and confirm the entry by clicking Ok.
5. Follow the instructions of the installation program.
Note!
The installation under Windows NT/XP/2000 requires administrator rights!
Show/Hide Bookmarks