Clearaudio EMOTION - Handbuch (Seite 20)

Emotion & Satisfy
Bedienungsanleitung/USER MANUAL
Seite/Page 20 © clearaudio electronic GmbH 2007
The following adjustment is very important:
should the air bubble in the level gauge not be in the black
circle (see at the blow up), please ensure then that your
underground so will be according aligned. Only if the
turntable will be aligned you will receive the optimum on
sound.
Take the threaded bolt (metric winding size 6) out of your accessory bag and screw it with
the adequate allen key into the winding near the tonearm cut of the
turntable chassis, so that the front of the bolt is not facing out the inner
side of the tonearm cut.
Now it’s the right time to mount your cartridge on your
Satisfy -tonearm.
Please use the manufacturer’s instruction manual while this installation
procedure and follow the appropriate instructions. The headshell wires (
cartridge connection leads ) are colour coded according to the
international standard :
Please pay attention on every step to avoid any damages to the cartridge !
Now take the
Satisfy -tonearm with the mounted cartridge (and
the stylus protector on it!) and slide first the signal cable and
then the tonearms shaft into the pre-drilled hole on the right
side of the
Emotion -Turntable body. Let the tonearm slide as
far into the hole as the cuing lever unit sits on the
aluminiumblock as shown in the beneath picture. If you like to
use a mat on the turntable platter, please consider to add the
thickness of the mat while adjusting the tonearm height.
Please ensure that the tonearm tube is in parallel to the right
edge of the turntable body. Fix this position while gently locking
the allen screw in the turntable-body’s edge.
Now adjust the tracking force of the cartridge. Please follow the
instructions according the manual of the cartridge you use. If you are using a clearaudio
Moving Magnet cartridge (e.g. clearaudio
aurum classics Wood ) you can adjust the force
(about 20 mN), by turning the tonearms counter weight on the threaded bolt until you can
see approximately eight threads (backside view of the tonearm). This works only if the lead
plate, which is part of delivery of the clearaudio cartridge, is not mounted under the
cartridge.
If you have problems with the adjustment of the tracking force you can also use tools like
the clearaudio
weight watcher gauge. For more informations on that, please contact your
specialist dealer or directly clearaudio. For contact address see page 10.
For the next settings place any LP. Now you can remove the stylus protector.
Colour code of the Satisfy tonearm wire:
Signal left channel (L+) → white
Signal ground left channel (L -)
→
blue
Signal right channel (R+)
→
red
Signal ground right channel (R -)
→
green