Clearaudio EMOTION - Handbuch (Seite 23)

Emotion & Satisfy
Bedienungsanleitung/USER MANUAL
Seite/Page 23 © clearaudio electronic GmbH 2007
4. Special information
To achieve the full clearaudio warranty, it is necessary that you fill out and send the
corresponding part of the warranty registration card back to clearaudio, within two weeks
after purchase. Only if the product is returned in it’s original packing clearaudio can provide
the warranty.
Transportation advice: If any transportation of the
Emotion -turntable should be
necessary, please always remove the turntable platter. Otherwise serious damage can occur!
The bearing hole needs to be covered as well, to avoid any dust coming into the bearing.
Always take of the pulley of the motor unit as well, to prevent the motor shaft from any
damages.
If the
Emotion -turntable is a longer time not in use, please disconnect the motor from the
mains supply.
Every two years you can lubricate (only if you will recognize speed variations) the bearing of
the turntable platter with the delivered oil. In this case it is enough to put 4 or 5 drops of the
oil into bearing.
Please take special caution to any damages of the power cord. Any damages should only be
repaired only by authorized personal. A damaged power cord must be exchanged
immediately!
Caution ! Please use only non alcoholic fluids and only fluids specially used for acrylic, to
clean the Emotion -turntable. Otherwise could occur damage to the material or the surface!!!
5. Service
In case of any necessary service for all clearaudio products should be done by authorized
personal only.
In case of any repair, the clearaudio
Emotion -turntable needs to be send to your nearest
authorized dealer or directly to the clearaudio factory.
Clearaudio electronic GmbH
Spardorfer Str 150
91054 Erlangen
Germany
Tel/Phon: +49-(0)1805/059595
www.clearaudio.de [email protected]
Send / ship the Emotion -turntable always and only in the original packing !!! Only in the
original packing clearaudio can provide the warranty.
If you repackage the turntable, please make all steps inverted like at installation and set up
(chapter 3)