Clearaudio SMART MATRIX - Handbuch (Seite 22)

Smart Matrix
l
Bedienungsanleitung / USER MANUAL
Seite 22 © clearaudio electronic GmbH 2006
Set-up and operation
5. Hold (with gentle pressure) the cleaning brush on the record, while the platter
makes aprox. 2 total turns in each direction ( left and right ).
6. If the record appears to be more dirty than usual, you might have to turn the
LP more and longer than recommended in point 5.
TIP :
For very dirty records, we recommend to follow up with a second or even third
cleaning and vacuuming process, while the platter turns more then 2 times per
each direction.
7. To vacuum the record, please swing the arm tube to the left towards the
center of the record or spindle, until the arm tube can be easily pushed down.
8. You can now start the vacuuming process, by switching on the „VACUUM“
button and waiting till the record surface is completely dry. Switch off the
“VACUUM“ and take off the secure puck. Flip over the record and clean the
other side in the same manner as previously described.
9. Please empty the fluid tank after 15 – 20 cleaning procedures. Take out the
fluid release tube at the back panel of the machine, till it stops automatically.
Don’t pull too heavy, as there is an inbuilt point of resistance. Take off the red
secure seal from the rubber tube. To empty the tank place or put the fluid
release tube in an appropriate tool to capture the fluid as it is flows out.
Replace the secure cap of the rubber tube.
Please keep in mind, the secure cap must always be on the tube. If not, malfunction
may occur or even damage the machine.
Please enjoy cleaning your records !