Gossen DIGISKY Benutzerhandbuch
Seite 18
GOSSEN Foto- und Lichtmesstechnik GmbH
18
6.2.2
Flash Light Reading
– Analysis
Use the ring controller ...
to select synchronization
speed and analyze flash
component.
Flash component is
displayed as a percentage.
i
Please note that some flash units must first be triggered once when set to lower power levels.
Stored power is still at the higher level, resulting in erroneous measurements.
i
The ratio between flash and ambient light can be influenced by changing synchronization
speed. This is interesting for brightening up the image with flash, or when ambient light is not
desired.
!
Warning in Case of User Error
A warning may be caused by any of the following conditions.
General:
Measurement has been performed outside of the measuring
range. There are no usable results
– EV display: OVR. Flash
was too bright or too weak. Change conditions and measure
again.
See also Technical Data
– Measuring Range on page 31.
NonCord
Time out
– Flash was not triggered during “flash standby time”.
Break
– Flash standby time was stopped by pressing the
measurement key.
Cord:
The synchronizing cable was not connected.
The synchronizing cable is defective and must be replaced.
Radio:
No flash regardless of setting:
Check menu settings.
RF module - RF channel on page 26.
Flash is only triggered in the “All” setting.
The menu settings are correct
– please select the right
group.