Gossen DIGISKY - Handbuch (Seite 9)

GOSSEN Foto- und Lichtmesstechnik GmbH 9
1 Preparation
The DIGISKY works with a device-specific, rechargeable lithium-ion battery.
Use the V070A rechargeable battery and the USB battery charger included with the
exposure meter.
1.1
How to Insert the Rechargeable Battery
1.2
How to Charge the Battery
1.3
Factory Settings
Amongst others, the following default settings apply during initial start-up of the DIGISKY:
ISO
100
Language English
EV steps 1
User defined settings can be entered via the main menu (see page 23).
Switch your DIGISKY off or wait until the exposure meter
is switched off automatically.
Unscrew the battery cover at the back of the meter with a
(Philips) recessed head screwdriver, and then pull it down
and out of the housing.
Insert the battery into the compartment as shown in the
figure. Make sure that the battery is inserted with correct
polarity (+ and
–)!
Then place the battery cover over the battery
compartment and secure it with the screw.
Connect the cable to the USB port at the exposure meter first, and then insert the
mains plug into an electrical outlet.
!
The battery can also be charged using a USB port at a PC. Remove the mains plug to this
end, and connect the USB plug to your PC.
The DIGISKY can be operated with an inserted battery, and while connected to a PC or to
mains power.
Proceed as described in section
1.1, “Inserting the Rechargeable Battery”, in order to
replace the battery.
To protect the battery pack and prolong its life, do not charge it for longer than 24 hours
without break.
Replacement battery: GOSSEN order no. V070A (3.7 V / 890 mAh)