HK Audio LipaN V1.2.0.4 - Handbuch (Seite 5)

5
3.4 The Group Window (Single Group View)
Figure 5: The Group window
LIPAN offers 16 color-coded groups that make managing your controllers
easier. It lets you adjust mute parameter value.
To view the window of any given group, double-click its icon in the
GROUPS box’s tree. The window is shaded when you change the view
from one group to another.
The Group view does not let you:
• View the IP address
• View the speaker series
• View the fi lter
• View further group routings
• View AES In and EXT Sync
• Lock keys
• Edit Stereo Input EQ
• Engage the Phase function
• View level
• View Delay
3.5 Soft Reset
LIPAN also offers a software reset that restores the original settings of
the following parameters on one or several controllers:
Soft Reset: (Press and hold Admin+Back+Enter for 3 seconds)
The default preset Null loads.
Functions:
• No speaker/ no filter selected
• No signal routed to the exits
• All FIR initial coefficients set to 0
• No filters set; filter must be reloaded!
• X-Over set to bypass
• Input/ output gain set to 0
• Delay parameter set to 0
• IIR EQs all input gains set to 0,
• IIR EQs output set to bypass (LIPAN Off) and gain to 0
• All limiters set to +10 dB threshold
• Admin parameters remain unchanged
• Outputs 1-4 muted
3.6 Stereo Input EQ
Figure 6: The Stereo Input EQ window
LIPAN provides a six-band IIR stereo input EQ with four fully parametric
and two multifunctional bands for every controller in the network (bands
1 and 6 may be confi gured as peak, shelf, or cut fi lters). These EQs serve
to equalize the entire system.
The controller EQ can only be edited in the LIPAN application, but its
setup is saved in the controller like all other parameter settings.
The icon that opens the Stereo Input EQ sits in the Main window just
below the menu bar and in the Controller window. Click it to open the
Stereo Input EQ window. Every band is color-coded for the sake of clarity.
EQ settings may be edited manually by typing values into the given
boxes, and graphically by clicking and holding the mouse button to drag
fi lters in the fi lter curve view.
You can edit the following parameters graphically:
• Left mouse button: Gain and frequency (+/– 15 dB; 20 to 20,000 Hz)
• Right mouse button: Bandwidth (the Q factor in a range of 0.5 to 10.0).
Note: Abrupt mouse movements and big jumps may cause distortion
that can harm your speakers, so drag the mouse smoothly and slowly.
You can also enter values to the boxes manually.
To do this, click the box, type in the parameter value, and press the Enter
key to confi rm and enable the setting.
English