Gastroback 42636 Design Espresso Machine Advanced Control - Handbuch (Seite 12)

50
operaTing
warning: Both the STEAM LEVER and
HOT WATER dial must be in the CLOSED
position for the machine to enter START UP
mode.
BeFore FirsT use
Machine preparation
Remove and discard all labelling and pa-
ckaging materials attached to your espresso
machine. Ensure you have removed all parts
and accessories before discarding the pa-
ckaging.
Clean parts and accessories (water tank,
portafilter, filter baskets, jug) using warm
water and a gentle dish washing liquid and
rinse well.
The water filter located inside the water tank
will need to be removed before washing the
water tank.
Conditioning the water Filter
1. Remove filter from the plastic bag and
soak in a cup of water for 5 minutes.
2. Rinse filter under cold running water.
3. Wash the stainless steel mesh in the pla-
stic filter compartment with cold water.
4. Insert the filter into the filter holder.
5. Set Date Dial 2 months ahead.
6. To install filter, push down to lock into
place.
7. Slide the water tank into position and lock
into place.
We suggest changing the water filter at least
every two month.
FirsT use
initial start up
• Fill tank with water
• Check Steam Lever and Hot Water dial is
in the CLOSED position.
• Press POWER On.
• A pumping sound will be heard indica-
ting empty boilers are being filled with wa-
ter for the first time.
• Machine will reach operating tempera-
ture and go into STANDBY mode.
Flushing The Machine
When the machine has reached STANDBY
mode, run the following 3 steps:
1. Press 2 Cup button to run water through
group head.
2. Run Hot Water for 30 seconds.
3. Activate Steam for 10 seconds.
Repeat this cycle until tank is empty.
Tip: You can maneuver your machine about
the bench using the drop down swivel foot
located under the drip tray.
sTarT up
Press the POWER button to switch the ma-
chine ON. The POWER button will flash and
the LCD screen will display the current es-
presso boiler temperature.
When the machine has reached operating
temperature, the POWER button light will
stop flashing and the MANUAL, 1 CUP and
2 CUP buttons will illuminate.
The machine is now in STANDBY mode rea-
dy for use.
noTe:You will not be able to select 1 CUP,
2 CUP or CLEANING CYCLE during START
UP. If you select one of these functions du-
ring START UP, the LCD will display BUSY.