Clearaudio Tangent (Tangential) - Handbuch (Seite 20)

Tangent
Bedienungsanleitung / User manual
Page / Seite 20  clearaudio electronic GmbH 2015
4. Tangent adjustment
For this adjustment now take an old, used vinyl. This LP should be flat and not too
thick. Instead of a LP you can also use the delivered linear tracking gauge, which is
nearly as thick as an LP.
Adjust little stylus pressure, while sliding the counterweight(s) in the direction of the
cartridge. The exact pressure will be adjusted later. Lift the cartridge with the cueing
lever down on the LP (or the linear tracking gauge). To achieve the right height of the
cartridge you have to loosen the two screws in the side of the tonearm (the base-side
with the RCA outlets), so that you can move the tonearm up and down on the two rods.
The two supporter screws (the tonearm rests on the supporter screws) had to be
adjusted in the same direction, that after changing the height, the tonearm will be
levelled and parallel as shown in the left picture (use the level gauge). The headshell
rod should be parallel to the surface of the LP. If so, you can fix the tonearm in this
position with the two screws again. You can lock the supporter
screws with the nuts.
B
C
A