Clearaudio Tangent (Tangential) - Handbuch (Seite 22)

Tangent
Bedienungsanleitung / User manual
Page / Seite 22  clearaudio electronic GmbH 2015
After that you have to adjust the azimuth (vertical needle-position in the groove). Take
a straight bar or rod (c) which is possible to be placed on the top of the cartridge. Place
this piece on your cartridge as shown in the left picture. Lift your cartridge up (!) before
doing this. Then lift your cartridge down on the LP and make sure that the straight bar
or rod is parallel to the turntable platter. You will have to loosen the screw in the
carriage holding the headshell in order to change the horizontal position of the
cartridge. Lock this screw again after finished your adjustments. Please take care, that
during this installation the position of the tonearm will not be changed.
Adjust the correct stylus pressure as instructed in the cartridge’s user manual. To
achieve the exact stylus pressure we recommend the use of the clearaudio digital stylus
pressure gauge “exact” (order-#: CAZB0085).
Please pay attention that the tonearm-cable makes a loop above the acrylic plate of the
tonearm.
The clearaudio Tangent is now complete assembled and set up.
c