Beurer PM 18 - Handbuch (Seite 20)

18
Press the MODE button for approx. 5 seconds. The settings flash if
you can change them. Change the settings with the
START/STOP/RESET and SELECT buttons. Switch between the
Hours, Minutes and Seconds settings with the MODE button, at the
same time the new values are stored.
Leave the setting menu again by keeping the MODE button pressed
for approx. 5 seconds.
Tip: If you keep the START/STOP/RESET and SELECT buttons
pressed for more than 2 seconds, then the relevant setting automati-
cally counts forwards or backwards.
You can start and stop the timer at any time with the
START/STOP/RESET button. To reset the timer settings press the
SELECT button for 2 seconds.
Alarm clock
Your HR monitor has an alarm clock, which emits an acoustic signal
when it reaches the wake-up time. Press any button (apart from
LIGHT) to stop the alarm.
Display the alarm clock
Press the START/STOP/RESET button when you are in the time
display
In this mode, the set wake-up time is displayed (in
the picture: 12 o’clock) and whether the alarm
clock is activated (in the picture it has been
switched off “OFF”).
As soon as you release the START/STOP/RESET button, you get
back into the time display.