Parkside PHD 100 D2 - Handbuch (Seite 10)

10
GB IE CY
Never operate the pressure washer
with a closed water tap. Dry run-
ning will damage the washer!
Be prepared for the recoil
force of the emitted wa-
ter jet! Ensure that you are
standing firmly and that you
are holding the gun ( A 5)
securely, otherwise you could
injure yourself or other peo-
ple.
• Switch on the pressure washer with the
ON / OFF switch ( A 5).
• Pull the lever of the gun ( A 10) to turn
on the washer.
• Hold the switch-on lever of the gun
( A 10) until there is no more air in the
pressure washer.
Releasing the lever will switch
off the washer, but the pressure
within the system is retained.
D
• Lock / unlock the switch-on lever
of the gun (10) by depressing
the locking button (17).
Lock the switch-on lever to prevent
the pressure washer from being in-
advertently / accidentally started.
Locked
Open
In case of leaks in the water
system, immediately switch
off the equipment at the on/
off switch (5) and disconnect
the mains cable (7) of the
equipment from the mains.
There is a risk of electric
shock. Start restoring the wa-
ter connections (see “Initial
Operation – Setup”).
If there is still air in the equipment,
please proceed as follows:
Bleed the supply hose:
1. Remove the quick connection for the
garden hose adapter on the water
connection (8) and open the water tap
until water with no bubbles emerges.
2. Close the water tap.
3. Connect the supply hose to the equip-
ment with the aid of the quick connec-
tion for the garden hose adapter (8).
4. Fully open the water tap.
Bleed the equipment:
5. Switch on the equipment at the on/off
switch (5) until the pressure has built
up.
6. Switch off the equipment at the on/off
switch (5).
7. Depress the start lever on the spray
gun (10) until the pressure is released.
8. Please repeat steps 5. to 7. several
times until there is no further air in the
equipment.
Interrupting operation
• Release the lever of the gun ( A 10).
• During prolonged work intervals turn
off the washer by its ON / OFF switch
( A 5).
Ending operation
• After working with cleaning agents,
run the equipment with clean water to
completely rinse the cleaning agent
from the pipes.