Parkside PT360 - Handbuch (Seite 12)

12
Igniting the flame
Continuous flame
Regulating the flame
2
1
3
1. Push the flame regulator (5) to position 4
2. Periodic operation
• Keep the safety switch (8) pressed and draw the ignition switch (7) to ignite the flame.
• Release the ignition switch to extinguish the flame.
3. Continuous operation
• Keep the safety switch (8) pressed and draw the ignition switch (7) to ignite the flame.
• Slide the continuous operation switch (4) to the in position CONT to lock the ignition
switch in the drawn position.
• Slide the continuous flame switch into the OFF position to extinguish the flame.
An irregular flame can be generated or gas can escape in fluid form If the gas soldering iron
is cold or has just been refilled. This is normal and does not indicate a fault. The flame will
stabilise once the device warms up (approx. 1-2 minutes).
Igniting and extinguishing the flame