Florabest FBM 575 A1 - Handbuch (Seite 16)

ENGLISH -
For the purchased device you will get 3 years
guarantee.
The warranty period begins on the first sale - the
purchase must be demonstrated by a valid cash
voucher.
Our guarantee covers all serious defects of the
unit, which are proved related to material or
workmanship.
In case of a justified complaint, we are entitled
to choose to either rectify or replace the product.
In addition to the warranty period of the warranty,
the following requirements must be fulfilled:
 The device has been properly, and according
to the recommendations of the manual, used in
the private sector.
 There should have been no attempt by
purchaser or an authorized third party to repair
the unit.
Normal wear, maintenance and adjustments are
excluded from the guarantee.
Following consumable parts are excluded from
warranty:
� knife
� cutter bar
� belt
� cables
� starter rope
� air filter
� spark plug
� other maintenance items
This guarantee is additional to, and in no way
diminishes the customer’s statutory rights.
Aktiebolaget Partner does not accept liability
under the warranty for defects caused in whole
or part, directly or indirectly by the fitting of re-
placement parts or additional parts that are not
either manufactured or approved by Aktiebolaget
Partner, or if the machine has been modified in
any way.
WARRANTY
RECYCLING
Perform service and maintenance according to the
instructions in this manual. In this way the engine
will last longer and the hazardous emissions are
minimized.
When the machine is worn out it should be dispo-
sed of for recycling. The machine is dismantled
and the parts are divided up in different materials
for recycling. Most parts of this machine are
recyclable.
GENERAL SERVICE
We are pleased that you have purchased a pro-
duct from our company. If, despite of all quality
assurance, a defect occurs, you should contact the
Authorized Servicecentre in your country stated
at the back of this manual.
Make sure you have all the necessary equipment
data at hand; it can be found on the label of each
product. The Service Agent will determine the
next steps with you. If repairs are necessary, the
device must be handed in to the Service Centre.
6
 To remove the blade (15) unscrew the
screw (16).
 Check the conditions of the blade-support (17),
the washer (18), the key (19) and the washer
(20) and replace any parts which are damaged.
 When reassembling, make sure that the key
(19) is correctly seated in the shaft and that the
cutting edges face in the direction of the engine
rotation. The blade screw (16) must be torqued
to 5,34 Kgm (52,4 Nm).
BLADE