United Office ULGD 350 A1 - Handbuch (Seite 11)

9 ULGD 350 A1
GB
IE
Preparing for cold lamination
IMPORTANT
► After hot laminating, allow the laminator to cool down completely before
beginning with cold lamination. Bear in mind, the rollers inside the laminator
will still be hot. This could damage the laminating pouch and the document
to be laminated!
♦ If not already done: Insert the document support into the two openings
under the pouch ejector slot , such that it is seated fi rmly on the appliance.
♦ Insert the plug of the laminator into a mains power socket.
♦ Switch the appliance on by placing the selector switch for hot and cold lami-
nation
5 at "Cold". The red indicator light Power 3 and the green indicator
light Ready 2 glow.
♦ Place the pouch thickness switch 4 at the corresponding pouch thickness
(see also chapter Switching levels).
♦ Place the document to be laminated into a laminating pouch of the appropriate
size.
NOTICE
► Ensure that all edges of the document have at least two millimetres of space
to the edges of the laminating pouch, as shown in Fig. 1 (see p. 8).
► Make certain that you use only one pouch for laminating. First open it up,
as shown in Fig. 2 (see p. 8).
► For further information about the lamination process, please read the section
Lamination process.
Lamination process
♦ Place the pouch centrally between the two A4 markings and with the closed
side towards the pouch slot
6 and on the supporting surface.
♦ Slide the pouch slowly and straightly into the pouch slot 6 .
♦ When you have slid the pouch several centimetres into the slot 6 it will then
be pulled in automatically. Release the laminating pouch as soon as you
notice it being pulled in automatically.
IMPORTANT
► Ensure that there is at least 30 cm of free space behind the laminator.
Otherwise, the pouch will not be ejected completely from the laminator
after lamination. This could damage the pouch.
♦ The fi nished and laminated pouch is ejected from the pouch ejector slot
of the laminator.