United Office ULGD 350 A1 - Handbuch (Seite 13)

11 ULGD 350 A1
GB
IE
Cleaning the inside of the appliance:
With every lamination, contaminants are deposited on the rollers inside the
laminator. Over time, this reduces the performance of the laminator.
You should therefore clean the rollers inside the laminator after use.
♦ Prepare the appliance for use, as described in the chapter Preparing for
hot lamination, until the green indicator light Ready
2 glows.
♦ Then guide a sheet of folded in the middle A4 paper (maximum thickness
1.0 mm), without a pouch and with the fold forward, slowly into the manual
pouch insertion slot
6 .
♦ Release the sheet as soon as you notice that it is being pulled in automatically.
The contaminants on the rollers inside the laminator now fi rmly attach themselves
to the sheet of paper. The paper will be ejected from the pouch ejector slot
of the laminator.
♦ Repeat this cleaning process several times. Use a fresh clean sheet of paper
each time.
When you no longer see any contaminants on the paper, the rollers inside the
laminator are clean.
Storage
The appliance has a built-in cable winder on the underside of the housing, on
which you can wrap the power cable when it is not in use. This prevents the
power cable from being pinched, damaged or soiled, and it cannot become
a source of danger by hanging loosely down.
♦ Store the appliance in a clean, dry place away from direct sunlight.
Disposal
Do not dispose of the appliance into the normal household
waste. This product is subject to the provisions of the European
Directive 2002/96/EC-WEEE (Waste Electrical and Electronic
Equipment).
Dispose of the appliance through an approved disposal centre or at your com-
munity waste facility. Pay heed to the currently applicable regulations. In case of
doubt, please contact your waste disposal centre.