Henkel LOCKTITE 97211 - Handbuch (Seite 22)

22
5 Measuring
5.5 Monitoring
5.5.1 Normal Monitoring Mode
Every dispensing cycle, which is started, will be monitored in the order of storage.
The quantity of the several dispensing can be different. So dispensing 0 can be different
in quantity from dispensing 1, dispensing 1 can be different from dispensing 2 and so
on. The order of monitoring these dispensing cycles is fixed. It will be monitored in the
order of storage.
For example:
Dispensing 0 with reference 0
Dispensing 1 with reference 1
Dispensing 2 with reference 2 and so on.
5.5.2 Extended Monitoring Mode

This option requires knowledge of serial data communication!
In this mode you can select several dispensing cycles for monitoring at your own choice.
Therefore you have to set up the serial interface at your PC or PLC, connect this
interface with the Loctite controller according to the pin assignment in the following and
send a command for the reference which is required.
Use the following serial I/O ports: Dual Channel Automatic Controller 97103 XS 8
Automatic Controller 97123 XS 4
Be sure to follow the sequence otherwise you get no result.