Sony SIR-3400H - Handbuch (Seite 128)

17-16
(E) SIR-3400H / SIR-3032i / SIR-3032W
Command Contents
TOC? TOC data readout
Command format TOC? <1><2><3>/[ ]
<1><2><3>: ID number
Returned format TOC : <1><2>...<25>
<1> : Start ID
0=Not start ID 1=Start ID
<2> : REC mode
0=16 ch analog mode (standard)
1=Full analog mode
2=Full digital mode (when SBS-10A/S is used)
3=Analog
+ digital mode
<3> : CH code
When <2> is 0, 1, or 3, which means analog CH mode.
1=2 ch, 2=4 ch, 3=8 ch, 4=16 ch, 5=32 ch, 6=64 ch, 7=96 ch, 8=128 ch
When <2> is 2, which means digital CH mode.
1=1 ch, 2=2 ch, 3=4 ch, 4=8 ch
<4> : Recording speed
0=1 x (normal speed), 1=1/2 x, 2=1/4 x, 3=1/8 x, 4=1/16 x,
A=2 x, B=4 x, C=8 x, F=EXT
<5> : Reservation
Always 0
<6>...<17> : Recording start time
<6><7> : Year (last 2 digits)
<8><9><10><11> : Month and date
<12><13><14><15><16><17> : Hours, minutes and seconds
<18> : Existence of pre-trigger recording
0=No pre-trigger recording 1=Pre-trigger recording
<19> : Existence of recording error
0=No write error 1=Write error
<20><21><22><23><24><25> : Actual recording length
hhmmss
Related command : VOL?
TRG? Trigger setting status
Command format TRG? /[ ]
Returned format TRG : <1>
<1> : 0=RSV
1=Pre-trigger single mode (low: start)
2=Pre-trigger multi mode (low: start, high: stop)
3=Normal single mode (low: start)
4=Normal multi mode (low: start, high: stop)
Related command : TRG
TRM? Terminator selection status (returned strings)
Command format TRM?/[ ]
Returned format TRM : <1>
<1> : 0=CR
+ LF, 1=CR, 2=LF
Related command : TRM
TSG? Test signal selection status
Command format TSG? /[ ]
Returned format TSG : <1>
<1> : Test signal selection
Analog channel
0= OFF
1=AC
2=
+DC
3= _DC
4= GND
Related command : TSG
17. Control by Telnet