Toshiba T2150CD - Handbuch (Seite 119)

4. Turn the computer on.
The computer automatically recognizes the external monitor and sends output to it.
If you have selected
Simultaneous
under the
Display
options of the TSETUP program, both the
external monitor and the internal LCD will be active when you turn on the computer. If
Internal/External
is selected, only the external monitor will be active.
To change the display settings, press Fn + F5. If you disconnect the monitor before you turn
the computer off, be sure to press Fn + F5 to switch to the internal display.
PS/2 Mouse
Use the PS/2 mouse port on the optional port replicator to connect a PS/2 mouse. See the
Port replicator section in this chapter for directions on connecting the port replicator.
Make sure you have a cable that has a 6-pin connector for the port replicator’s mouse port. If
the mouse’s cable is not compatible, see your dealer for an adapter cable.
NOTE
How the computer treats the connection to a PS/2 mouse depends
on the setting for
Pointing Devices
under the
Others
options in the
Setup program. If
Simultaneous
is selected, you can operate both the
AccuPoint and the PS/2 mouse. If
Auto Selected
is chosen, the
AccuPoint is disabled when a PS/2 mouse is connected.
To connect a PS/2 mouse:
1. Turn the computer off.
2. Connect the PS/2 mouse to the PS/2 mouse port.
3. Before turning on the computer connect the mouse, pressing gently to assure a firm
connection. If you connect the mouse while the computer is on, you will have to reboot
for the computer to recognize the mouse connection.
To disconnect the mouse, turn off the computer and pull out the mouse connector.
Consult your mouse manual for instructions on how to install necessary software.
If you have a serial mouse, refer to Connecting a serial mouse in the section, Interfacing
for serial devices, later in this chapter.
PS/2 Keyboard