Toshiba T2150CD - Handbuch (Seite 142)

The diskettes must be write enabled. For 3 1/2” diskettes, the write-protect tab must
be closed so you cannot see through it.
These disks must also be formatted. See Chapter 5, Disks and Drives, for more
information on write enabling and formatting disks.
Press Enter when you’ve inserted the disk(s) in the drive(s). The test begins and
displays:
FLOPPY DISK IN PROGRESS 503000
If there is an error, the
ABORTED
message appears. Write down the highlighted numbers
and press Ctrl + Break to return to the
DIAGNOSTICS MENU
. If a disk drive fails, check
the following:
Disks are properly formatted.
Disks are not damaged.
Try another disk and if there is still a problem, consult your dealer.
NOTE
If you change your mind and decide not to test a disk, press Ctrl +
Break to return to the
DIAGNOSTICS MENU .
Hard Disk Test
If the diskette test passes, and you selected to test the hard disk, you see the
following message:
HARD DISK IN PROGRESS 805000
If this test aborts, write down any messages and consult your dealer. The computer or
the drive may require service. Press Enter to return to the
Diagnostics menu
.
Printer Test
If the hard disk test passes and you selected to test the printer, you see the following
message:
PRINTER TEST IN PROGRESS 60xxxx
where xxxx is a counter that shows the test is still in progress.
If you specified an IBM compatible printer, the test prints six lines that show normal,