WolfVision VZ-C10 User Manual - Handbuch (Seite 12)

TELE WIDE
PRESETS
14
13
INFRARED REMOTE CONTROL
12
If the Visualizer can only be controlled from a close distance, or if it
cannot be controlled at all with the infrared remote control, you may have
to change the batteries.
Open the cover on the back of the remote control by hand and replace
the two 1.5 V AA batteries with new ones.
Check the polarity of the batteries!
Please note that an infrared remote control can only be used up to a certain distance from the unit. Objects situated
between the Visualizer and the infrared remote control, and weak batteries, interfere with the reception.
If you want to work with more than one Visualizer in the same room, the units
should be set to different infrared codes, in order to control them all individually.
To change the infrared codes on the Visualizer, enter the
"Misc. Settings" and set the
"IR Code" to A, B, C or D (code A is default).
To change the infrared code on the remote control, simultaneously press
PRESET 1, PRESET 2
and ZOOM TELE
ress PRESET 1, PRESET 2 and
ZOOM WIDE
on-screen menu, by
pressing the menu-key (#19) for one second, go to
(#14) (#13) - each time this key
combination is used, the code switches from A to B, C, D ... A ...etc. For resetting
the remote control to code A simultaneously p
(#13).
CLEANING
ipe the mirror gently with a soft (!) and lint-free tissue (no paper!). Normal dry
cleaning or cleaning by breathing on the mirror should be sufficient (If not, use a special optical cleaner only!).
Please note, that dust on the mirrors (#2, 3) inside the unit has little effect on the picture quality (as it is out of the
focal range). When necessary, w
IMPORTANT: This is a sensitive front coated mirror!
Move the tissue in vertical direction only ! (Horizontal scratches
can cause ugly reflections) Avoid high pressure !
Cabinet: Clean the cabinet by gently wiping it with a soft cloth. Never use strong cleaning agents such as
benzene or alcohol!
DO NOT USE ORDINARY GLASS CLEANER OR ALCOHOL
- THE RESULT WOULD BE A SLIGHTLY BLUE MIRROR SURFACE !
External Infrared (IR) Sensor
In some rooms the 2 built-in infrared receivers of the VZ-C10 may not be enough. In this case connect the supplied
external infrared receiver to the IR-sensor plug (#38) and position the IR-sensor somewhere on the ceiling (or in
the room) where the users normally point the remote control at.
IMPORTANT
front back (open)
ALL
WIDE
IMAGE TURN
A A
IRIS
EXT / INT
POWER
MEMORY
TELE
PRESETS
FOCUS
MENU
HELP
LIGHT TEXT
LA
SE
R
-
+
-
+
X X