Electrolux EHH9967FOG - Handbuch (Seite 14)

discolorations. Use a special cleaning
agent for glass ceramic.
• The surface of the hob has horizontal
grooves. Clean the appliance with a
moist cloth and some detergent with a
smooth movement from left to right.
• At the end rub the appliance dry with
a clean cloth.
7. TROUBLESHOOTING
Problem Possible Remedy
You cannot activate the
appliance or operate it. Activate the appliance
again and set the heat
setting in less than 10
seconds.
You touched 2 or more
sensor fields at the same
time. Touch only one sensor
field.
The STOP+GO function
operates. Refer to the chapter “Dai-
ly Use”.
There is water or fat
stains on the control pan-
el. Clean the control panel.
An acoustic signal
sounds and the appliance
deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated. You put something on
one or more sensor fields. Remove the object from
the sensor fields.
The appliance deacti-
vates. You put something on the
sensor field
.
Remove the object from
the sensor field.
The residual heat indica-
tor does not come on. The cooking zone is not
hot because it operated
only for a short time. If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
The Automatic Heat Up
function does not oper-
ate. The cooking zone is hot. Let the cooking zone be-
come sufficiently cool.
The highest heat setting
is set. The highest heat setting
has the same power as
the Automatic Heat Up
function.
The heat setting changes
between two levels. The Power management
is activated. Refer to “Power manage-
ment”.
The sensor fields become
hot. The cookware is too large
or you put it too near to
the controls. Put large cookware on
the rear cooking zones if
necessary.
14 www.electrolux.com