Installation instructions, 1 built-in appliances, 2 connection cable – Electrolux EHH9967FOG Benutzerhandbuch

Seite 16: 3 to attach the seal

Advertising
background image

Problem

Possible

Remedy

The cooling fan is
blocked.

Check if objects block the
cooling fan. If the error
message comes on
again, speak to the serv-
ice center.

comes on.

The electrical connection
is incorrect. One or more
phases are missing.

Have a qualified electri-
cian check if the installa-
tion is correct with the
connection illustration. If

comes on again,

speak to the service cen-
tre.

If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit letter
code for the glass ceramic (it is in the cor-
ner of the glass surface) and an error
message that comes on.

Make sure, you operated the appliance
correctly. If not the servicing by a custom-
er service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the cus-
tomer service and conditions of guarantee
are in the guarantee booklet.

8. INSTALLATION INSTRUCTIONS

WARNING!
Refer to "Safety information"
chapter.

Before the installation

Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................

8.1 Built-in appliances

• Only use the built-in appliances after

you assemble the appliance into correct
built-in units and work surfaces that
align to the standards.

8.2 Connection cable

• The appliance is supplied with the con-

nection cable.

• Replace the damaged mains cable with

a special cable (type H05BB-F Tmax
90°C; or higher). Speak to your local
Service Centre.

8.3 To attach the seal.

• Clean the worktop in the area of the cut

out section.

• Bond the seal stripe supplied on the

lower edge of the appliance along the
outer edge of the glass ceramic. Do not
extend it. Let stay the cut ends in the
middle of one side. When, you cut it to
length (add some mm), push the two
ends together.

16 www.electrolux.com

Advertising