Electrolux EHH9967FOG - Handbuch (Seite 8)

3.4 OptiHeat Control (3 step
Residual heat indicator)
WARNING!
\ \ The risk of burns
from residual heat!
OptiHeat Control shows the level of the
residual heat. The induction cooking
zones make the heat necessary for cook-
ing directly in the bottom of the cookware.
The glass ceramic is hot from the heat of
the cookware.
4. DAILY USE
4.1 Activation and deactivation
Touch for 1 second to activate or de-
activate the appliance.
4.2 Automatic Switch Off
The function deactivates the
appliance automatically if:
• All cooking zones are deactivated (
).
• You do not set the heat setting after
you activate the appliance.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, wait for
the cooking zone to cool down.
• You use incorrect cookware. The sym-
bol comes on and the cooking zone
deactivates automatically after 2 mi-
nutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
comes on and the appliance
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
, - — 6 hours
•
- — 5 hours
•
- — 4 hours
• - — 1.5 hours
4.3 The heat setting
Touch the control bar at the heat setting.
Move your finger along the control bar to
change the setting. Do not release before
you have a correct heat setting. The dis-
play shows the heat setting.
When you use cookware larger than 180
mm the manufacturer recommends that
you put it on the rear cooking zones.
4.4 Bridge function
The Bridge function connects two cook-
ing zones and they operate as one. You
can use this function for cookware larger
than 260 mm.
First set the heat setting for one of the
cooking zones.
To activate the Bridge function touch
and the indicator comes on. To set or
change the heat setting, touch one of the
control sensors.
To deactivate the Bridge function touch
and the indicator goes off. The cook-
ing zones operate independently.
4.5 Automatic Heat Up
You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see
the diagram), and then decreases to the
necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
8 www.electrolux.com