Allied Telesis x900 Series Switch Benutzerhandbuch
Seite 11
Installation and Safety Guide
11
When the switch boots for the first time, it automatically creates an
account with manager privileges. The login name for the account is manager
and the password is friend.
At the login prompt, enter the login name and password as follows:
Login: manager
Password: friend
The switch’s command prompt is displayed for you to use the CLI to
configure it.
5.
Change the password.
Change the password as soon as possible because a manager account with
the default password is a serious security risk. Remember the new
password because there is no way to retrieve it if you forget it.
To change the account password, use the set password command.
6.
Configure the switch.
Refer to the Software Reference for more information about configuring
the software.
7.
Configure the switch. If you do not know the command syntax, use any of
the following to help you:
To display a list of help topics, use the help command.
To display help on a specific topic, use the help <topic> command.
To display a list of valid options, type a question mark or press the Tab key
at the end of a partial command.
To complete a parameter after you have typed enough letters to uniquely
match the desired one, press the Tab key.
8.
Save the configuration.
Save your configuration to a new file by using the command:
create config=filename.cfg
Then set the switch to load this file when it restarts by using the command:
set config=filename.cfg