Allied Telesis AT-200 Series CentreCOM - Handbuch (Seite 11)

4
4. Place the cable in the cable channel of the tap body.
Figure 2: Assembling the Coaxial Active Tap
5. Slide the clamp assembly onto the tap body until it stops.
6. Using the hex wrench, thread the button socket screw into the clamp frame
until the pressure block bottoms on the clamp track and holds the cable
securely.
Use only the coring drill supplied separately in the coaxial active
connector installation tool kit, model AT-1220-K, to drill the thick
Ethernet cable.
7. Insert the combination nut driver/coring drill through the hole in the tap
body. Drill through the cable to the center conductor. The coring drill end
has a stop to prevent overdrilling.
8. Inspect the hole to be sure no particles remain.
Hand-tighten only. Do NOT over-tighten or damage could result.
9. Using the nut driver end of the tool assembly, thread the probe assembly
into the tap body until the probe assembly is firmly seated.
10. If installed, remove the two long panhead screws from the transceiver
body.
Clamp assembly
Socket screw
Tap body
Probe assembly
Braid terminator (2)
Cable
Pressure block
!
Caution
!
Caution
613-10423-00Book Page 4 Monday, March 4, 1996 2:29 PM