AEG AR 4029 DAB - Handbuch (Seite 29)

English
29
Connection
WARNING:
During installation damages may occur!
Have the unit installed by a specialized workshop, if
possible.
Please observe all installation and connecting instruc-
tions for safe and trouble-free operation if installing the
unit yourself.
CAUTION:
Wrong connections may damage the unit.
Use the ISO connectors when installing the unit.
Vehicle-specific ISO adapters are available at the spe-
cialized car accessories trade, if necessary.
Rear Panel Connections
A ISO connector B (speakers)
B Vehicle flat fuse (15 A)
C ISO connector A (power supply)
D LINE OUT:
RCA audio output L/R for amplifier
E Antenna connector
F Screw connection for the DAB antenna
Configuration ISO Connectors
ISO connector A 1 Not connected
2 Not connected
3 Not connected
4 Continuous plus (memory)
5 Control voltage for electron-
ic/motor antenna or power
amplifier
6 Not connected
7 12 V (ACC)
8 GND
ISO-Anschluss B 1 Speaker rear right +
2 Speaker rear right -
3 Speaker front right +
4 Speaker front right -
5 Speaker front left +
6 Speaker front left -
7 Speaker rear left +
8 Speaker rear left -
CAUTION:
Use speakers with an impedance of at least 4 Ohm.
The speaker cabling must be floating ground.
NOTE:
For connecting the unit to two speakers only use only
front speaker cables.
Please observe that for the station memory connector 4
must be connected to continuous positive.
In some vehicle models the standard configuration for
connectors [4] and [7] (ISO A) is inverted. In this case
the station preset can get lost. To remedy invert these
connections 7 (ACC) and 4 (continuous positive).
Auto Antenna Power Supply A5 (ISO A)
CAUTION:
Damage to the unit is possible!
Do not connect the terminal for antenna power to the
power supply of the antenna.
Max. load: 100 mA.
The terminal for antenna power is provided for a relay-con-
trolled antenna. The relay automatically extends the antenna
when the radio is turned on. The antenna retracts again when
the radio is turned off. This terminal can also be used for an
external amplifier. Please find details in the amplifier’s manual.
Connect External Amplifier
Connect an external amplifier via LINE OUT (D). Please find
details in the amplifier’s manual.
Installation and Removal
The unit can be installed in any ISO installation slot. Please
contact the car manufacturer or the local dealer if your vehicle
does not come with an ISO slot.
NOTE:
Before installation remove the two transport securing
screws.
Connect all cables before mounting the unit. Ensure all
connections are correct and the system works properly.
Important additional information for installation of your
car radio!
1. The set is designed for an installation where the negative
pole of the battery must be connected to the vehicle
chassis. Please check this before installatio.
2. Please note for installation/connection of your set that
not every vehicle is equipped with an “ISO connection”.
In this case we recommend the use of a vehicle-specific
ISO adapter.
Adapters are available from car accessory sellers and/or
your car workshop.