AEG AR 4029 DAB - Handbuch (Seite 32)

English
32
Insert battery into remote control
NOTE:
Before using the remote control for the first time, you
must insert the supplied battery to make the remote
control ready for use.
The life of the supplied batteries may be shortened
due to storage conditions.
Open the battery compartment of the remote control.
Place the battery into the battery compartment with the
positive pole at the top.
Close the battery compartment again.
Start-up
To protect against theft remove the front panel. Do not keep
the front panel in the car.
NOTE:
Keep the front panel in its casing.
Do not touch the contacts on the unit or on the front
panel.
Attach Front Panel
Set the control panel with the left-hand side first into the
frame.
Then push the right-hand side in until it clicks into place.
Flip the control panel up until it clicks into place.
Ensure the front panel is attached properly. If the front
panel is not attached properly this can cause malfunc-
tions.
Detach Front Panel
Press the release button (1) and flip the control panel
down.
Then pull gently on the right-hand side of the control
panel to detach the control panel.
Replace the remote control batteries
The battery of the remote control is a long life lithium cell. If
the range of the remote control becomes shorter whilst in
use, follow the steps below:
Open the battery compartment of the remote control.
Replace the cell with a battery of the same type (CR
2025). Make sure that the polarity is correct.
Close the battery compartment.
If the remote control is not in use for long periods, please
remove the battery to prevent “leakage” of battery acid.
WARNING:
Do not expose batteries to intense heat or direct sunlight.
Never throw batteries into a fire.
Risk of explosion!
CAUTION:
Batteries should not be disposed of with household waste.
Take spent batteries to designated collection points or to a
dealer.
Operation
This chapter gives important operating instructions for the
unit.