AEG AR 4029 DAB - Handbuch (Seite 38)

English
38
NOTE:
Some makes of mobile phones have a power saving
mode. Please deactivate power saving mode since
otherwise there may be problems when phoning via
Bluetooth.
To be able to conduct an incoming or outgoing conver-
sation, Bluetooth must remain activated on your mobile
phone. Please refer to the user manual for your mobile
phone.
Please ensure that you speak towards the integrated
microphone (12). An external microphone cannot be
connected.
Disconnect devices (#/SCAN button (20))
The devices are connected if you switch off the car radio
via the ignition or on the unit.
Keep the #/SCAN button (20) pressed to disconnect the
devices as well. DISCONN is shown on the display (9).
Reconnect devices (#/SCAN button (20))
This unit supports automatic reconnection.
The requirements are:
The devices have already been registered.
Bluetooth is activated on your mobile phone.
Your mobile phone supports this function.
After the car radio has been switched off and on again via
the ignition or on the unit, the automatic reconnection is
activated. This may take a few seconds.
CONN TRY is shown
on the display (9).
If the connection has been restored,
CONN OK appears on
the display.
NOTE:
Alternatively, you can also briefly keep the #/SCAN
button (20) pressed. CONN TRY is shown on the
display (9) as well.
Phone menu settings
This menu can only be opened if a device has been success-
fully connected to the car radio.
Press the T-MENU/TRANS button (16).
Press the T-MENU/TRANS button again to open the
next setting item.
Turn the VOL multicontroller (6) to change the displayed
settings.
The following settings are available:
PRE
NUM Here you have access to the 10 saved speed dial
numbers. To allocate a speed dial number, follow
the steps below:
Using the VOL multicontroller (6), select a
storage space (0-9).
NOTE:
If a memory location is empty, EMPTY is
shown on the display. If a memory loca-
tion is already occupied, the stored phone
number is displayed.
Confirm your selection with the SEL button (6).
DIAL is shown on the display.
Enter with the help of the numeric buttons
the desired phone number.
Save the phone number by pressing the SEL
button. SAVE OK is shown on the display.
NOTE:
If you have entered one or more numbers
incorrectly, you can delete the numbers
using the
/LOU/BND button (15).
Press briefly: The numbers are deleted
individually.
Keep pressed: All entered numbers are
deleted.
The saved speed dials are lost if the car ra-
dio has been reset using the RESET button
(29).
Use a saved speed dial number
Press the button (5). DIAL is shown on
the display.
Now keep the corresponding numeric button
pressed to call the desired phone number.
CALLING appears on the display.
RE-
CEIVED Here you can display a list of the last received
phone numbers. Press the button (5) to call the
displayed number.
DIALED Here you can display the last 10 dialed phone
numbers.
MISSED Here you can display missed calls.
PHONE-
BK
You can copy 20 telephone numbers from your
mobile phone. These are then shown in this
menu. To transmit telephone numbers from your
mobile phone, proceed as follows:
In your mobile phone, select the contact call-
ing card that you wish to transfer.
Select the “Send calling card/contact data by
Bluetooth” option. Transmit the data to the
car radio. The contact data will be automati-
cally transferred.
If you want to delete a telephone number
from the PHONE BK, select the number
and keep the /LOU/BND button (15)
pressed.