Weidmuller AI8 - Multi channel signal transmitter - Handbuch (Seite 25)

5
Mode
• Run mode
Run mode is the normal operating mode of the AI8. During run
mode the AI8 scans the inputs; calculates internal variables; updates
the display, alarm relay states and analogue outputs; and, if digital
communications are fitted, sends information to the master when
requested. It will also allow setpoint adjustment, acknowledgement
of latched alarms and review of set-up parameters via the front panel
keypad and display.
EXIT
Micromann Multi+
AI8 Version 2.10
Alarm Sequence
3 1 2 4
MV1= 56.9 %
MV2= 27.0 %
MV5= 56.9 %
MV6= 27.0 %
MV7= 56.9 %
MV8= 27.0 %
AO1= 56.9 %
FM1= 27.0 %
AO2= Disabled
MV3= 56.9 %
MV4= 27.0 %
2 s
MENU
ENT
EXIT
15 s
Review Mode
Prev Next
Calibration Mode
Prev Next
SP1= 56.9 %
Ave= 27.0 %
SP2= 56.9 %
Ave= 27.0 %
SP3= 56.9 %
FM1= 27.0 %
SP4= 56.9 %
Ave= 27.0 %
SP1 56.9 %
Ave= 27.0 %
Raise Setpoint
ENT Save Changes to Setpoint
MENU Accept Alarm 1
EXIT Accept Alarm 4
ENT Select mode
EXIT Return to Run mode
Lower Setpoint
Setup Mode
Prev Next
*Automatic Scrolling only
You can setup the unit to scroll automatical y
through values MV1 thru AO2 or
through the inputs on y (MV1 thru MV8).
Allowed timeouts are from 2 to 20 s.
Manual scrolling (through all the values)
sti l works as shown.
2-20 s*
2-20 s*
2-20 s*
2-20 s*
2-20 s*
2-20 s*
2-20 s*
2-20 s*
2-20 s*
All Alarms Accepted Alarm T
rigger
ed
Automatic Accept Mode
Manual Accept Mode*
Accept Alarm 2
Accept Alarm 3
*Alarm LEDs Flash until accepted
Alarms accepted automatically
and unit remains in Run mode