Weidmuller UHZAR - Universal glavanically isolated signal converter - Handbuch (Seite 21)

21
PowerSupplyRequirements
Check the power supply against the model number before applying
power to the instrument. Micromann modules must be used with a
suitable mains Power Supply, ratings are as follows:
Voltage Range Nominal Voltage Power Frequency
100–132 V AC 110 V AC 6 VA 47-63 Hz
200–264 V AC 240 V AC 6 VA 47-63 Hz
12–50 V DC* 24 V DC 6 W (at 24 V DC) -
*Using a DC power supply that provides this voltage will comply with
the instrument’s UL/CSA listing.
•Calibration
General
The UHZ/AR is factory calibrated and will operate with any input or
output format without recalibration.
During calibration allow a few seconds for signals to stabilise before
accepting the value.
7
Link to change the set-up Security Link
8
9 Neutral (−)
Power supply
10 Live (+)
11 Channel one
Alarm outputs 12 Channel two
13 Common
14 Output +
Analogue outputs 15 Current −
16 Voltage −
Case Earthing is via a stud on lower side of case
Connections(continued)