Weidmuller UPIT - Analog to frequency converter - Handbuch (Seite 17)

1
Reviewingthesetup
For review mode, press the
Å and ì keys simultaneously.
Press the Å and ì keys to move through the setup sequence (see
table). Greyed items in the setup table are not shown in review mode.
A 10s timeout applies for review mode or you can press ï to quit.
Note: You can use review mode while the instrument is in service and
the analogue and alarm outputs will still operate correctly.
Clearingtrippedalarms
You can acknowledge a tripped alarm by simply pressing the ï key.
Displayingthealarmsetpoint
To check a setpoint, simply press the ï key. If the alarm is disabled the
display will show ---- .
Adjustingthealarmsetpoint
To change a setpoint, hold down the ï key. You will then be able to
change the value using the arrows. Release the ï key to save the
value.
Note: There are limits for the setpoint values that depend on the input
range setting and you cannot change the value if setpoint security is
on.