Salter Brecknell LP-250 Series - Handbuch (Seite 37)

ASCII Data Hex decimal data related to
left column of ASCII data
Note:
1. Dump mode requires 2” wide paper width.
2. Turn off / on the power to resume printer for normal
printing.
3 Press FEED button to back to the previous menu
4.3.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green after 5 amber blinks. (Any green will do during
the 5 blinks).
•
The LED color will be changed as following:
Amber red (5 amber (5 blinks)
solid green green (5 blinks) green/amber (5 blinks)
red/amber (5 blinks)
Printer configuration will be restore to defaults as below after initialization.
31
Parameter Default setting
Speed 127 mm/sec (5 ips) (203DPI)
Density 8
Label Width 2” (50.8 mm)
Label Height 4” (101.6 mm)
Sensor Type Gap sensor
Gap Setting 0.12” (3.0 mm)