FRITSCH PULVERISETTE 7 premium line - Handbuch (Seite 46)

2. The PKM interfaces board (81.0011.00) is on the rear panel, with
the slot (f) for the receiver module 81.0013.00.
3. Insert the receiver module in the corresponding slot. (As illus‐
trated)
4. Close the rear panel of the housing again and screw it tight.
2.6 Activating EASY GTM
If the device is protected by SOP mode (see the operating manual PUL‐
VERISETTE 7 premium line chapter 6.1 "Standard Operation Procedure"),
please contact the PULVERISETTE‐7 administrator. This mode must be
deactivated, otherwise only programs already stored can be loaded for
operation.
To activate the EASY GTM system, proceed as follows:
EASY GTM Gas Pressure and Temperature Measuring System
‐ 46 ‐