VACUUBRAND Digital Interface - Handbuch (Seite 16)

Seite/page 16 / 19
Das Dokument darf nur vollständig und unverändert verwendet und weitergegeben werden. Es liegt in der Verantwortung des
Anwenders, die Gültigkeit dieses Dokumentes bezüglich seines Produktes sicher zu stellen. BA-Nr.: 999221 / 27/05/2009
Documents are only to be used and distributed completely and unchanged. It is strictly the users’ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999221 / 27/05/2009
Description of the digital I/O interface
The digital I/O interfaces are accessories for VACUUBRAND
- Controller CVC 3000 from software version V 1.00 (configuration from software version V 1.30, see
section “Configuration of the interfaces”).
- Controller VNC 2 from software version V 1.00
- Measurement device DCP 3000 from software version V 1.00 (configuration from software version
V 1.00).
The digital I/O interface is designated to be connected to the VACUU•BUS TM female plug (with extension
cable VACUU•BUS TM ).
Connect the digital I/O interface only if the device is shut off.
When switching on the device the analyzable digital I/O interfaces are detected automatically, depend-
ing on controller / measurement device. Not analyzable digital I/O interfaces are ignored.
Each of the digital I/O interfaces need an individual BUS address (see section “Configuration of the
interfaces”). Do not use interfaces with the same address within one BUS system. Configuration of the
interfaces is possible with the controller CVC 3000 or the measurement device DCP 3000.
At the CVC 3000 the digital I/O interfaces can be used after appropriate configuration as
- fault indicator (factory set)
- remote (start-stop) module
- end module
- valve adapter module for valves at hand
At the VNC 2 the digital I/O interfaces can be used after appropriate configuration as
- fault indicator (factory set)
- remote (start-stop) module (only after configuration with CVC 3000 or DCP 3000)
At the DCP 3000 the digital I/O interfaces can only be used in the delivery status as fault indicator.
Error messages when removing (pull off at the controller) a digital I/O interface
CVC 3000 and VNC 2: Interfaces configured as fault indicator or remote module lead to an error mes-
sage.
The error message due to a removed digital I/O interface has to be reset by loading the factory setting
at the controller.
Attention: If loading the factory setting at the controller CVC 3000 all programs are deleted!