VDO WR Z3 - Handbuch (Seite 127)

32
EN
ning ranges are captured for each running timing function (see chapter
Kap. 14). The setting range/measuring range for all timing functions is
0:00:00 h to 24:00:00 h
TIMER 1: You can program a time e.g. for interval training. TIMER 1
counts from zero forward. At the end of TIMER 1 there is a single beep.
Timer 1 only functions if you have set a time. If you have forgotten to
set a time your VDO computer displays TIMER ERROR
TIMER 2: You can program a time, e.g. for the rest phase in an interval
training. TIMER 2 counts from zero forward. At the end of TIMER 2 there
are two beeps. Timer 2 only functions if you have set a time. If you have
forgotten to set a time your VDO computer displays TIMER ERROR
TIMER 1+2 runs until you stop these functions. Timers 1 + 2 only
function if you have set a time. If you have forgotten to set a time your
VDO computer displays TIMER ERROR.
COUNTDOWN: You can program a time, the timer will count backwards
from this time. At the end of the COUNTDOWN time there is a single
beep. Countdown only functions if you have set a time. If you have
forgotten to set a time your VDO computer will display COUNTDOWN
ERROR.
LAP TIMER: Start Lap Timer with ∫ . Start next Lap with ≈ + ¥ at the
same time at any point of the training unit. The following values will
be saved:
- Duration of the lap
- Average heart rate on the lap
- Average speed on the lap
The lap values can be called at any time if time measurement is
stopped.
STOPWATCH: With the manual stopwatch you can manually capture the
plus values of training units.
13.1. SELECTING THE TIMING FUNCTION
3 sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ TIMER SETTINGS
‚ TIMER ?SELECT?
Select ‚ TIMER 1 ?SELECT?
Timer ∂ TIMER 2 ?SELECT?
∂ TIMER 1 + 2 ?SELECT ? >>> Query repeats TIMER
1 + 2 REPEATS ?SELECT?
∂ COUNTDOWN ?SELECT?
∂ LAP TIMER ?SELECT?
∂ STOP WATCH ?SELECT?
‚ Confirm selection SET DONE
If you have not yet set any values for timer 1, timer 2, timer 1 +2, or
countdown, then your VDO computer will now show ERROR in the
display. In this case proceed as explained in the following chapter 13.2
Setting the timer.