Livarno 3978/062L - Handbuch (Seite 7)

7 GB/IE
CauTIon! A damaged mains lead presents
a serious danger to life from electric shock. In
the event of damage, repairs or other problems
with the lamp please contact the service centre
or an electrician.
J Before installation, remove the fuse for this
circuit or switch off at the circuit breaker
(0 setting) in the fuse box.
J Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (230 - 240 V ~).
J Never let the lamp come into contact with
water or other liquids.
J Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing
can lead to a serious danger to life from
electric shock.
J Do not install the lamp on a moist and conduc-
tive surface!
To avoid danger of
fire and injury
J RISk of InjuRy! Check every bulb and lamp-
shade for damage immediately upon unpack-
ing. Do not fit the light if the bulbs and / or
lampshades are faulty. If they are, contact the
service point for a replacement.
J RISk of InjuRy fRoM BuRnS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Bulbs give off a lot
of heat around the top of the lamp.
J Replace any faulty bulbs with new ones immedi-
ately. Before replacing the bulb, always remove
the fuse or switch the automatic cutout off.
J
0.5 m
fIRe HazaRD! Fit the light so that
it is at least 0.5 m away from the
material illuminated. Fire can result
from the development of too much heat.
J Do not allow the lamp or the packaging materials
to lie around unattended. Plastic film or bags,
Styrofoam etc. can turn into dangerous toys for
children.
Working safely
J Only use 230 - 240 V ~ bulbs with a G 9 base
and a maximum output of 40 Watts.
J Fit the light in such a way to ensure it is
protected from damp and dirt.
J Make careful preparations for the assembly
and take sufficient time. Clearly lay out all com-
ponents and any additional tools or materials
that might be required so that they are readily
to hand.
J Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
Q
Preparation
Q
Required tools and materials
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only. The nature of the
material depends on the individual circumstances
on site.
– Pencil / Marking tool
– Voltage tester
– Screwdriver
– Electric drill
– Drill
– Edge cutter
– Ladder
Q Before installation
Important: The electrical connection must be
carried out by a qualified electrician or someone
trained to perform electrical installations. This per-
son must be familiar with the features of the light
and the connection requirements.
j Familiarise yourself with all instructions and dia-
grams in this manual as well as with the light
Safety / Preparation / Before installation