Silvercrest SKRI 2000 A1 - Handbuch (Seite 49)

46
Setting up and connecting
SKRI 2000 A1
GB
Appliance battery
With the insertion of a battery you can avoid the loss of programmed times
and dates plus alarm times in the event of a possible power failure. The battery
ensures that the internal clock and date continue to run even during a power
failure. The display
will then automatically show the correct time on the resto-
ration of mains power.
NOTICE
The appliance can also be operated without a battery. ►
Inserting / replacing the battery
Open the cover of the battery compartment ♦ 24 on the underside of the
appliance by turning the cover with a coin as far as it will go to the left
and then lifting it off .
Insert the battery type CR2032 (supplied) into the battery compartment. ♦
The side with the marking + points upwards.
Close the battery compartment by attaching the cover and then, using a ♦
coin, turn it all the way to the right.
Remote Control Battery
Activating the battery
The remote control battery is already inserted when delivered.
Activate the battery by removing the isolation strip. ♦
Changing the battery
Using a fingernail press the recess (A) to the right ♦
and, at the same time, pull the battery compart-
ment out.
Insert a 3 V battery of type CR 2025 in the ♦
battery compartment. The side with the marking
"+" must point upwards.
Slide the battery compartment completely back ♦
into the remote control.
IB_63920_SKRI2000A1_LB1.indb Abs3:46 17.01.2012 11:15:14 Uhr