Burkert Type 8643 - Handbuch (Seite 8)

28
cable glands 8.3.
Warning!
Danger of explosion!
No explosion protection if cable glands are defective or
wrong.
Replace defective cable glands only with Ex-autho- •
rized (Ex e II) cable glands with adequate application
temperature range (see Appendix of the Operating
Instructions / Type Examination Certificate).
At the factory all cable glands are sealed with a •
plug (protection class IP65).
Seal all unused cable glands with a plug to
•
maintain IP protection (IP65).
english 29
M16x1.5 potential equalisation
PA (with plastic housing)
4 black M20x1.5 cable glands bus and power
supply
8 blue M20x1.5 cable glands for intrinsically
safe circuits (sensor/actuator outputs)
Cable glands on the metal housing Fig. 4:
The housing features eight blue cable glands for the intrin-
sically safe circuits and four black glands for the bus and
power supply with increased safety.
The bus and power supplies each have two M20x1.5
glands to loop through the supply lines.
english
30
For sensors and actuators each output (with two sensors)
has an M20x1.5 cable gland.
Devices with plastic housing have an M16x1.5 cable
gland for the internal earth connection (PA).
Devices with metal housing (e.g. aluminium) have an
earth connection on the outside of the housing.
electrical connections 8.4.
safety instructions 8.4.1.
note!
Incorrect polarity!
No function if reverse polarity.
Pay attention to the polarity of the terminals! •
The device is protected against polarity reversal. •
english 31
overview of the terminals and 8.4.2.
outputs
LED module
Address
BUS
Power supply 24 V DC
(4-wire device only)
Bus
Shield
Actuators and Sensors
Overview of terminals and outputs Fig. 5:
english
Type 8643