Retsch EasySieve - Handbuch (Seite 12)

General Notes
12
• AS 300 control
• AS 400 control
• AS 450 control
For control purposes, the sieving machine must be connected to the computer
through a free serial interface (RS232).
Automatic weight transfer is also possible from a balance equipped with a serial
data interface. EasySieve can accept manually input data too of course.
The evaluation can be conducted at a separate time from the measurement, i.e.
the raw data can be inputted again later and evaluated. The raw data contains the
name of the associated sieving task. This is loaded when a raw data file is read if
another sieving task was active beforehand. Consequently the raw data is always
evaluated with the parameters that were set in the sieving task at the time of the
evaluation. This makes it possible to evaluate measurements at a later point in
time with altered parameters.
To prevent an accidental alteration of the parameters in a sieving task, password
protection can be activated in EasySieve with two user levels:
1. Measuring mode:
• Measurements and evaluation are possible. The measuring mode
is particularly suitable for routine operation.
2. Task mode:
• In addition to the measuring mode, it is also possible to create and
alter sieving tasks. EasySieve is always in task mode if the
password protection has not been activated.
The task mode is intended for qualified users with a very good
knowledge of the program.
Note:
The following describes all the menus active in the task mode. Some of the
menus described are inactive in the measuring mode and accordingly not visible.
The files in which the sieving tasks are defined are filed in the sub-
directory...\SIEVESYS . The measuring results are filed as consecutive files in the
sub-directory… \ SIEVEDAT \ <Name of sub-directory>. The sub-directory is
defined in the sieving task. An increment postfix will be created automatically by
the software in order to prevent existing sieving files being overwritten.
Example:
Directory: Sand
File name: Test
File no.: 6
The sieving result is stored in the following raw data file.
...\SIEVEDAT\Sand\Test006.rdf
The creation of the following files is optional.
...\SIEVEDAT\Sand\Test006.ccg
...\SIEVEDAT\Sand\Test006.xld
...\SIEVEDAT\Sand\Test006.xle
Pos: 4.5 /00005 Überschriften/1.1 Ü berschriften/1.1 Ü berschriften BDA/11 D ateisystem @ 1\mod_1248959987053_9.doc @ 12807 @ 2 @ 1
4.1 File System
Pos: 4.6 /00020 BD A Software/20010 EasySieve Kapitelsammlung/0003 EasySieve Allgemei ne Hinweise zu Easy Si eve/0303 EasySieve Modul Dateisystem (Beschreibung der D ateistruktur) @ 1\mod_1254123800742_9.doc @ 14658 @ @ 1