Parkside PFBS 160 A1 - Handbuch (Seite 12)

12 GB/IE/CY
General power tool safety warnings / Start-up
off! Avoid contact with rapidly rotating drill /
grinder components.
Securely support the work-
piece. Use clamps or a vice to grip the workpiece
firmly. This is much safer than holding it in your
hand.
RISK oF INJURY! Never
support yourself by placing your hands near or
in front of the device or the workpiece surface.
A slip can result in injury.
DANGER oF FIRE FRoM FLYING SPARKS!
Abrading metal creates flying sparks. For this
reason, always make sure that nobody is placed
in any danger and that there are no inflammable
materials near the working area.
DUST HAZARD! Any
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
NoXIoUS FUMES!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
Its use as a saw or the use of saw blades with
this device is prohibited.
Do not soak the materials or the surface you are
about to work on with liquids containing solvents.
Avoid abrading paints containing lead or other
substances hazardous to health.
Do not machine materials containing asbestos.
Asbestos is a known carcinogen.
Avoid contact with moving sanding or grinding tools.
Do not machine moist materials or damp surfaces.
NoTE! Do not allow the tool to come to a
standstill by overloading it!
RISK oF INJURY!
Switch the device off and allow it to come to a
standstill before you put it down.
Always keep the device
clean, dry and free of oil or grease.
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited must
never be allowed to use the device without super-
vision or instruction by a person responsible for
their safety. Children must never be allowed to
play with the device.
original accessories / tools
Use only the accessories and attachments de-
tailed in the operating instructions, or those which
are compatible with the tool.
Start-up
Attaching / changing the
tool / collet
Press and hold the spindle lock 8 .
Turn the clamping nut 6 until the lock catches.
Loosen the clamping nut 6 using the combi-
nation wrench 33 for the thread.
If applicable, remove the attached tool.
First slide the tool you wish to use through the
clamping nut
6 before inserting it into the
collet 7 fitting the tool shaft.
Press and hold the spindle lock 8 .
Insert the collet 7 into the threaded insert, then
tighten the clamping nut 6 using the combina-
tion wrench 33 on the thread.
Using a tool with clamping mandrel:
Use the screwdriver end of the combination
wrench
33 to loosen and tighten the screw on
the clamping mandrels.
Insert the clamping mandrel in the tool as de-
scribed.
Using the combination wrench 33 , loosen the
screw on the clamping mandrel.
Insert the attachment you wish to use onto the
screw between two washers.
Use the combination wrench 33 to tighten the
screw on the clamping mandrel.
Grinding bits
Firmly secure the brick 23 ! Use a vice or equiv-
alent tool to prevent injuries.
Start-up