iStorage 1TB diskAshur PRO2 USB 3.1 Encrypted Portable HDD - Handbuch (Seite 14)

#14
iStorage diskAshur PRO
2
®
Manual – v 3.0
www.istorage-uk.com
20. Set Read-Only in User Mode
To set the diskAshur PRO 2 to Read-Only, first enter the “ User Mode ” as described in section 18. Once the drive is in User
Mode (solid GREEN LED) proceed with the following steps.
1. In User mode, press and hold down “ 7 + 6 ”
buttons. (7= R ead + 6= O nly)
Solid GREEN LED will change to blinking
GREEN and BLUE LEDs
2. Release 7+6 buttons and press “ UNLOCK ”
GREEN and BLUE LEDs will change to a solid
GREEN LED indicating the drive is configured
as Read-Only
Note : 1. This setting is activated the next time the drive is unlocked.
2. If a User set the drive as Read-Only, Admin can override it by setting the drive as Read/Write in
Admin mode.
3. If Admin set the drive as Read-Only, the User cannot set the drive as Read/Write
21. Enable Read/Write in User Mode
To set the diskAshur PRO 2 to Read/Write, first enter the “ User Mode ” as described in section 18. Once the drive is in User
Mode (solid GREEN LED) proceed with the following steps.
1. In User mode, press and hold down “ 7 + 9 ”
buttons. (7= R ead + 9= W rite)
Solid GREEN LED will change to blinking
GREEN and BLUE LEDs
2. Release 7+9 buttons and press “ UNLOCK ”
GREEN and BLUE LEDs will change to a solid
GREEN LED indicating the drive is configured
as Read/Write
Note : 1. This setting is activated the next time the drive is unlocked.
2. If a User set the drive as Read-Only, Admin can override it by setting the drive as Read/Write in
Admin mode.
3. If Admin set the drive as Read-Only, the User cannot set the drive as Read/Write
Important : If data has just been copied to the diskAshur PRO 2 , make sure to properly disconnect the drive
first by clicking ‘Safely Remove Hardware/Eject’ the diskAshur PRO 2 from the Operating System before
reconnecting and setting the diskAshur PRO 2 as ‘Read-Only/Write-Protect’.