T+A Elektroakustik P 10 Benutzerhandbuch
Seite 41
Problem:
The machine does not respond to
remote control commands after you fit
new batteries in the remote control
handset (only when the remote control
address has been changed using special
software).
Cause:
The remote control was set to remote
control address 2 before you changed
batteries. This setting is lost when you
change batteries.
Remedy:
Switch to remote control address 2 (see
remote control operating instructions).
Problem:
The source devices connected to the
system does not respond to remote
control commands.
Cause 1:
The unit you are trying to control is not
selected as source device, i. e. the
commands from the remote control
handset are being passed to a different
source device.
Remedy:
Press the corresponding source button on
the remote control handset and try again.
Cause 2:
The source device is not connected via an
R
LINK
cable.
Remedy:
Complete the connection as shown in the
wiring diagram.
Problem:
Loud humming noise from the
loudspeakers.
Cause:
Poor contact between the Cinch plugs
and sockets, or a faulty Cinch cable.
Remedy:
Please check all connections and cables
thoroughly.
41