Xoro HRS 8600 CI - Handbuch (Seite 83)

HRS 8600 CI 19
Engl
ish
First steps
1. Single connection of dish and receiver
The satellite dish is aligned to a special satellite and you use one LNB. Each LNB is directly
connected to the satellite receiver.
After choosing the satellite make sure that only following parameters are defined:
Satellite: ASTRA
19.2
LNB Type: Universal
LNB Frequency 09750/10600
Transponder: e.g. 11303/22000/H
22KHz: AUTO
LNB voltage: On
DiSEqC: None
Satellite
Here you can choose the satellite which you want.
LNB Type
Here you can define the LNB type. To receive digital DVB-S and DVB-S2 signals, please uses the
setting Universal.
LNB Frequency
This option is usually associated with the selected LNB type and varies depending on the LNB type. If
the LNB type Universal has been selected, then the corresponding frequency 9750/10600.
Transponder
This option is usually associated with the selected LNB type. Normally not changes are necessary,
only by manual searching.
22 kHz
By using the 22 kHz signal combined with a universal LNB it is possible to receive the whole ASTRA-
satellite system (analogue & digital) with a single 60cm satellite dish. For receiving digital TV and
radio only a Set-Top-Box is needed.
The digital TV programs are all arranged in the higher frequency band -> use the option AUTO
LNB Power
The LNB for digital programs is usually supplied with 13 and 18V. The option is automatically 13/18V.
The voltage can be changed manually. This directly influences the search results. Possible options
are: OFF, 13V, 18V and 13/18V. If the option OFF is activated the LNB is not supplied with power any
more which inflicts that no programs can be received any more.
Channel Search