AEG 43036IW-MN - Handbuch (Seite 32)

Stainless steel or aluminium ap-
pliances
Clean the oven door with a wet
sponge only. Dry it with a soft
cloth.
Do not use steel wool, acids or
abrasive materials as they can
damage the oven surface. Clean
the oven control panel with the
same precautions. 11.1 Shelf supports
You can remove the shelf supports to
clean the side walls.
Removing the shelf supports
1. Pull the front of the shelf support
away from the side wall.
1
2
2. Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
Valid with telescopic runners:
The retaining pins on the tele-
scopic shelf runners must point
to the front!
CAUTION!
Make sure that the longer fixing
wire is in the front. The ends of
the two wires must point to the
rear. Incorrect installation can
cause damage to the enamel.
11.2 Cleaning the oven door
To make the cleaning easier, remove the
door.
WARNING!
Make sure that the glass panels
are cool before you clean the
glass door. There is a risk that
the glass could break.
WARNING!
When the door glass panels are
damaged or have scratches, the
glass becomes weak and can
break. To prevent this, you must
replace them. For more instruc-
tions, contact your local Service
Centre.
32 www.aeg.com