Xoro HRS 8900 Hbb+ - Handbuch (Seite 69)

25
10.1 Automatic Search Satellite
To perform an Automatic Satellite
Search first mark the Satellite on
which you would like to perform the
search. You will notice that on the
right side of the screen you can now
alter the settings fort he selected
Satellite. Please make the changes
according
to your Antenna
Configuration. You can choose
between:
DiSEqC 1.0 (up to 4 Ports), DiSEqC
1.1 (up to 16 Ports), DiSEqC 2.0
(Motor) and USALS (Motor). Please
allocate the Port according to the
desired Satellite.
After setting up the first Satellite, please confirm with the OK key. After this select
the next Satellite that you would like to set up and proceed as previously with the
1st Satellite thus setting up all Satellites on which you would like to perform a
channel search.
To begin the search on the selected
Satellite(s), press the RED (Scan) key
and choose whether you would like to
search for all channels, only free-to-air
or only scrambled channels.
If you would like to perform a Network
search, please choose the according
option. Please note that in this case,
the receiver will search for new
information, however the search time
increases by far.
Begin the search with the RED key (Scan).