WolfVision EYE-10 User Manual - Handbuch (Seite 10)

+ 12V
GND
POWER PLUG
The connected power supply has to be approved from UL
or CSA in accordance to CSA 22.2-60950 or UL 1950 and
the power supply output is LPS (limited power source)
rated.
When a locked power connector and/or other power
supply are necessary, the supplied power connector can
be used.
9
EXTERNAL INFRARED (IR) SENSOR
In some rooms, the built-in IR-receiver may not be enough. In this case connect the supplied external IR-
receiver to the IR-SENSOR plug (#8) and position the IR-sensor somewhere on the ceiling (or in the room)
where users normally point the remote control towards.
BOTTOM LIGHT / LIGHTBOX (optional)
An external lightbox (bottom light) is recommended for
dark transparent material such as x-rays or for very small
transparent material such as slides.
When a lightbox is used, the room light may should be
dimmed or switched off.
When light conditions change, a white balance adjustment
should be performed to compensate the varying color
temperatures of different light sources - see page 5.
WolfVision offers lightboxes for x-rays,
slides and transparencies in two sizes:
LB-38: 430 x 359 mm (16.9" x 14.1")
LB-9: 300 x 210 mm (11.8" x 8.3")
Details at: www.wolfvision.com
Tile Bridge (optional)
The Ceiling Tile Bridge is designed to help install the
EYE-10 Camera into a standard grid of a suspended
ceiling (2" x 2" or 2" x 4").
The Tile Bridge is made of aluminium to insure a light but
sturdy construction. It fits standard ceiling grids in
American and European sizes.
The EYE-10 is attached to the Tile Bridge via a camera
mount. The mount can be rotated 360 degrees and moved
across the tile bridge, in order to align the camera with the
working surface.
A white trim ring is included to dress up the ceiling tile once
the EYE-10 is properly adjusted and in place.