WolfVision EYE-10 User Manual - Handbuch (Seite 9)

FIRMWARE UPGRADES
The software (firmware) of the EYE-10 can easily be upgraded to the latest version.
The firmware update can be done via the serial port (RS-232).
Firmware update files can be downloaded for free at www.wolfvision.com/support. Updates can be
made with WolfVision's Camera Control Software.
EXTRA MENU
Press the MENU key (#19) for 4 seconds until the extra menu appears on the screen.
Please note that the functions of the on-screen, as shown below, may change after a firmware update.
(layout shows firmware v1.10c)
Please note:
If a setting is marked with “!”, it has been changed with the RS-232 control software. This is only a temporary
change, until the camera is disconnected from the power. To change a setting permanently, change the
setting in the on-screen menu.
EYE-10 V1.10c Extra Menu
Baudrate 9600 ( 115200, 230400, 460800, 921600)
Framerate 30fps (12, 15, 20, 25)
Max. Gain 0x3ff (0x096 to 0x3ff)
Image Rotation 0 (180)
Pixel Calibration for trained personnel only
Exit
19200, 38400, 57600,
RS-232, SERIAL PORT
9-pin D-Sub connector on unit
male (front side)
The serial port (#9) can be used to control the EYE-10 through an external device, like a remote control
system for a complete conference room or for image transfers with the camera control program (the
camera control program can be download from WolfVision's homepage: www.wolfvision.com/support).
Pins: 2: RX, 3: TX, 5: GND, 7: RTS, 8: CTS
Baud rate: 9200, 19200, 38400, 57600,
(selectable)
ata bits: 8
top bit: 1
arity: no
115200, 230400, 460800,
921600
D
S
P
5
9
2
7
3 4
8
1
6
The complete serial protocol can be found on our internet homepage: www.wolfvision.com /support
8
For image transfer, a high speed RS-232 port on the computer side is recommended in order to take the
advantage of up to 921600 baud/s as supported by the camera.
The use of a high quality, short length cable is recommended for high baud rates (at 921600 baud/s max.
2m).
Baud Rate
The baud rate of the serial port can be set to 9600, 115200, 230400, 460800, 921600 baud/seconds.
Frame Rate
The frame rate can be set to 12, 15, 20, 25 or 30fps (30f/s are default). After changing, the camera should be
disconnected from the power source.
Maximum Gain
With Maximum Gain the automatic gain (AGC) can be limited to a lower value to reduce noise.
Image Rotation
The image can be rotated by 180°.